This is the "Solid G" heading hold gyro from Curtis Youngblood Enterprises. This high performance heading hold gyro is for heart pounding 3d maneuvers. Fully optimized for aggressive 3D and Precision flying, and features an amazingly constant pirouette rate and solid straight line hold. Allows for the use of any tail servo, and is a breeze to setup.
The Solid G allows for the use of any tail servo currently available on the market, from the Futaba 9256 to the JR 8700g. All you have to do is pick which servo you will be using from the menu and plug it in. Also the unit allows you to select the type of helicopter you are flying. Vibe, Stratus, Trex 600 and Synergy all have preprogrammed "base maps" to make it that much easier to tune the unit to your machine.
Sensor Type: SMM (Silicon Micro Machine)
Weight: 68g (38g amp) + (30g sensor)
Dimensions: 44x28x11.5mm (1.73x1.1x0.45") (amp)
Dimensions: 30x30x18 mm (1.18x1.18x.71") (sensor)
Gain Type: Transmitter-controlled remote gain
Operating Voltage: 4.8V to 7.0V DC
Reversing Switch: Yes, via G-View unit
High/Low Frame Rate Select: Yes, operates with all current frame rates
Servo Travel Limiter: Yes
Power consumption: 70mA (@5.0V, including sensor)
Note - The Solid G was designed to be used with the G-view. So everyone that gets a Solid G should also get a G-view (in our opinion). We do not pack them together as a set because once you purchase 1 G-View you do not need to buy any more. You can set up the Solid G gyro without the G View, but we strongly recommend getting a G-view for programming the Solid G.